![]() ![]() Once this warning is launched, your phone will not be able to charge. The phone’s highly sophisticated system can detect a fake lightning cable, which is one of the effects. Fake Lightning CableĪ fake lightning cable for your iPhone can make it send you false warnings about detecting liquid when it is not wet. If the lightning connector isn’t wet and you’re getting the error, then you need to change your lightning cable and fix the error. If you do notice that the lightning connector is wet, then you need to get liquid out of the lightning connector. Sometimes rather than letting you know that there’s an issue with your lightning cable, your iPhone will say that liquid has been detected in the lightning connector even if it’s not wet. Your iPhone says Liquid detected in the lightning connector either because there’s liquid in your lightning connector, or you’re using the wrong lightning cable and there’s a glitch on your iPhone that’s letting you know that there’s a problem with your lightning cable indirectly. Why Does Your iPhone Say Liquid Detected in Lightning Connector? So, just to ensure that everything is in the right place, you need to apply a few precautionary fixing techniques to prevent further damage that liquid might bring. It could well be a system glitch that could have prompted this error. It could be other lighting accessories you use. The reason why disconnecting the lightning connector isn’t enough is the fact that this error doesn’t necessarily mean that the lightning port is the one that’s wet or has a trace of moisture in it. However, disconnecting the Lightning connector isn’t enough, there are a few other things that you need to do after disconnecting the cable. This is a warning message that can protect you and your device from permanent damage. To protect your iPhone, disconnect this Lightning accessory and allow the connector to dry.” Liquid has been detected in the Lightning connector. Thanks in advance to anyone who has a piece of the information.After the iOS 10 update, iPhone users now receive a new error message that states “Disconnect lightning accessory. Switched to one of the Apple made cables, and the problem isn't being reported.ĭoes anyone know whether the detection is done in the phone, or in the cable circuitry? Is it measuring leakage currents and seeing a mismatch across pins (similar scheme as ground fault detectors)? Same problem, where I get the message when the new cable is connected. Let it sit for 20 minutes, and powered the phone back up. ![]() Thought, if the connector on the iPhone 11 pro max had something on the pins/pads it could explain why the problem didn't show on the iPhone 12 Pro max, so I powered down the phone and cleaned the contacts with a small amount of alcohol on a slender swab. The only other piece of info that might be useful is the warning message doesn't appear right away (> 5 minutes) - so it's possible it could be a heat up issue for the monitoring circuitry. Could be a combination of things, or different sensitivity between phones, but don't have enough info on what is being measured. Could be a iPhone 11 Pro max problem, but would think the problem would exist with the Apple manufactured cable. To confuse the matter, this problem doesn't appear when I connect this cable to an iPhone 12 pro max. I have the same issue with some cables I just purchased when connected to an iPhone 11 pro max - this is the second batch of cables (9), so trying to determine where the problem exists. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |